EASY TO USE

Install a 9V battery (not included) and place the alarm on the floor, or hang the alarm and extend the sensor to the floor, into the sump pit, or anywhere you need to keep dry; mounting holes in the sensor allow it to be secured to any surface.

Installing the battery:

You may want to mark the battery expiration date on a piece of tape and attach it to the alarm as a reminder to replace it when needed.

• Remove the cover on the battery compartment located on the right side of the alarm
• Extend the wires and snap a 9-volt onto the connector.
• Place the battery back in the compartment
• Replace cover

Positioning the sensor:

• The sensor is located on the bottom of the alarm
• The alarm can be placed directly on the floor with the sensor compartment closed, or the sensor compartment can be opened and the
  sensor wires extended to reach a sump pit another remote location. The alarm can be hung on a nail or screw in the wall with the sensor extended, and the sensor can be secured in place through the holes in the sensor panel. Six (6) feet of wire are attached to the sensor, but up to 100 feet can be spliced into the line.

Replacing the battery:

Replace the battery if the alarm has operated for an extended period of time, or if the battery expiration date is approaching.